Left.2016-20. Right.2016-20. type 2. Wheel opng mldg clip. A Clip which helps secure the Liftgate Latch Handle to it's mounting point. A Clip which helps secure the Tailgate Molding to it's mounting point. A component used to attach the fender emblem to its mounting point. A Nut used to secure the Liftgate finish panel to it's mounting point. A securing fastener which helps hold the Liftgate Reveal Molding in place. A securing fastener which helps hold the Side Panel Molding in place. A securing fastener which pushes in or snaps into place to secure the Side Marker Lamp. A solid metal or plastic block with a threaded hole in the center which is used to tighten or adjust the Liftgate Reveal Molding. A threaded rod with a drive head (such as hex, 12 point, torx, etc.) on one end used to secure the Tailgate Molding to it's mounting point. Clip that attaches the hood seal to the hood. Clip used to secure the luggage carrier Side rail. Door Molding Clip. Door Molding Nut. Fender Molding Retainer. Hood Scoop Clip. Liftgate Finish Panel Clip. Liftgate Latch Handle Nut. Rocker Panel Molding Clip. Rocker Panel Molding Nut. Spoiler Clip. Wheel Arch Molding Clip. Included with: Applique, Applique panel, Blank cover, Front Rocker Molding, Lower Molding, Molding, Nameplate, OutSide Handle, Rear Molding, Rear Rocker Molding, Repeater Lamp, Rocker Molding, Rocker Molding Part cannot be reused/reinstalled, Scoop, Side rail, Spoiler, Spoiler assembly, Upper Molding, Upper Molding Part is package with 20 Retainers, Wheel opening Molding.